Summary

This article lists what is in the Ingenico iPP350 Bolt terminal box and shows you how to set up the device and connect it to the Bolt service.

Before You Begin

What is in the box:

• Ingenico iPP350 Bolt terminal
• Ingenico multi-point mono connector cable
• Ingenico power supply

Steps

Connect the Device

1. Plug the power supply connector into the jack on the Multipoint Interface Cable.
2. Connect the Multipoint Interface Cable to the Multipoint Port on the back of the device.
3. Connect the other end of the cable to an Ethernet port on a router, modem, wall jack, or similar.
4. Plug the power supply adapter into a power outlet.

Confirm Connectivity

1. When the device gets power, it starts up.
2. When the device gets an IP address, it tries to call the Bolt service. If it connects, the device shows Connected. If not, it shows Disconnected, which means it did not connect to the internet.
3. When it shows Connected, the device is ready to use. You can leave it on or unplug it from power when needed.

If Something Goes Wrong

If the device shows Disconnected, test several ports on the router or modem to see whether you can connect the device to the internet.

Related Articles

• Ingenico iPP350 Bolt Terminal Topic Outline
• Access and Navigate Bolt S.O.S. Menu How-To
• Configure Ingenico iPP350 Bolt Settings Reference